Sidewall Traceability

Read the code moulded into the sidewall, then check it against what the curing press was supposed to produce.

JPEG or PNG · the code must be in frame
Or pick an example

Character tint shows the model's own confidence · amber below 90%, red below 75%

No image loaded

Moulded Sidewall Code

—
Idle
The decoded TIN will appear here.
MES Reconciliation
Select an expected code above to compare what the mould actually produced against what the production order specified.

Surface Defect Detection

Classify the tyre surface and show which regions drove the decision, as a Grad-CAM heatmap over the image the model actually saw.

JPEG or PNG · whole tyre or close crop
Or pick an example
70%

The heatmap shows which regions drove the model's decision

No image loaded

Assessment

—
Idle
The assessment will appear here.
Provenance

This demo runs on public road-tyre imagery (TyreNet, CC BY 4.0 — collected at vehicle service stations). The classes shown are therefore in-service failure modes: ozone cracking, impact bulge, brake flat-spotting. They are not post-cure line defects. The same detection pipeline retrains on a plant's own post-cure reject set to target bare spots, mould flash, open tread splices and vent spew.